Zipper Sinnet Bracelet With Quick Release

Zipper Sinnet Bracelet Materials: Two 5 ft pieces of 550 paracord Or one 10 ft piece of 550 paracord.

Step 1: If using two pieces, join them together. Make a loop near the center with the right side over the left side.

Step 2: Fold the left cord to form a second loop.

Step 3: Insert the second loop down through the first loop. Pull the first loop closed.

Step 4: Try to hide where the two pieces of cord are joined. Leave the second loop about an inch long.

Step 5: Flip the loop upside down. Form a loop with the right cord with the working end on the bottom.

Step 6: Fold the left cord and bring it up through the first loop.

Step 7: Pull the right cord to close the loop tight.

Step 8: Fold the right cord and insert it through the new loop. Pull the left cord to close the loop tight.

Step 9: Fold the left cord and insert it through the loop. Pull the right cord to close the loop tight.

Continue repeating steps 8 and 9 alternating left and right cords until you reach the desired length.

To finish, insert the end not forming the last loop through the loop. Then pull the loop closed.

Use the remaining length to tie a diamond knot or other desired knot.

If you would like to have this as a quick deploy bracelet, we suggest using a simple overhand knot rather than a diamond knot.